I’ve used apcupsd quite a lot, and intended to use it to protect our qnap, but
but the default on qnap is to use a system called
two are quite similar so the transition wasn’t too hard; the main problem was
trying to remember I wasn’t running apcupsd.
The package was already installed on the qnap, so all there was to do was plug
in the UPS (an APC Back-UPS
and navigate to the config section `Control Panel -> External Device-> UPS.
Turn off the server after AC Power fails for minute(s): 2
Enable network UPS master
* notify in the event of a power failure
The model number and battery capacity should appear in the section at the bottom
of this page.
nut exists as a pacakge in debian so install it, then here are the non-empty